IGMP Configuration Command Set
Configuring IGMP
10-12 Matrix DFE-Platinum and Diamond Series Configuration Guide
10.4.2.5 set igmp grp-full-action
Use this command to determine what action to take with multicast frames when the multicast group
table is full.
set igmp grp-full-action action
Syntax Description
Command Defaults
Flood multicast frames to the Vlan
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to flood multicast frames to the VLAN when the multicast group table is
full:
action Specifies the action to take when the multicast Group Table
is full. The options are:
• 1-send multicast frames to Routers
• 2-flood multicast frames to the VLAN
Matrix(rw)->set igmp grp-full-action 2
To Next Page
Loading...
Need help?
General