Enterasys Matrix 2G4072-52 - Set Port Inlinepower

General Configuration Command Set
Configuring Power over Ethernet (PoE)
2-114 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.5.17 set port inlinepower
Use this command to configure PoE parameters on one or more ports.
set port inlinepower port-string {[admin {off | auto}] [priority {critical | high |
low}] [type type] [powerlimit powerlimit]}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable PoE on port fe.3.1 with critical priority:
port-string Specifies the port(s) on which to configure PoE.
admin off | auto Sets the PoE administrative state to off (disabled) or auto
(on).
priority critical |
high | low
Sets the port(s) priority for the PoE allocation algorithm
to critical (highest), high or low.
type type Specifies a string describing the type of device connected
to a port.
powerlimit
powerlimit
Sets the maximum power allowed on this port in
megawatts. Valid values are 0 - 15400.
Matrix(rw)->set port inlinepower fe.3.1 admin auto priority critical