Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-113
6.2.2.21 clear spantree adminedge
Use this command to reset a Spanning Tree port to non-edge status.
clear spantree adminedge port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset fe.1.11 as a non-edge port:
port-string Specifies port(s) on which to reset edge port status. For a
detailed description of possible port-string values, refer to
Section 4.1.1.
Matrix(rw)->clear spantree adminedge fe.1.11
To Next Page
Loading...
