Enterasys Matrix 2G4072-52 - Set Physical Assetid

General Configuration Command Set
Setting Basic Device Properties
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-89
2.2.3.37 set physical assetid
Use this command to set the asset ID for a module.
set physical assetid module module string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the asset ID information for module 1 to “dfe1”:
module module Sets an asset ID for a specific module.
string Specifies the asset ID.
Matrix(rw)->set physical assetid module 1 dfe1