Logging And Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
11-130 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.6.8 set sntp poll-interval
Use this command to set the poll interval between SNTP unicast requests.
set sntp poll-interval interval
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the SNTP poll interval to 30 seconds
:
interval Specifies the poll interval in seconds. Valid values are 16 to
16284.
Matrix(rw)->set sntp poll-interval 30
To Next Page
Loading...
