Port Configuration Command Set
Disabling / Enabling and Naming Ports
4-36 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.3.2 set port enable
Use this command to administratively enable one or more ports.
set port enable port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Fast Ethernet port 3 in module1:
port-string Specifies the port(s) to enable. For a detailed description
of possible port-string values, refer to Section 4.1.1.
Matrix(rw)->set port enable fe.1.3
To Next Page
Loading...
