Logging And Network Management Command Set
Managing Switch Network Addresses and Routes
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-99
11.2.5.1 show arp
Use this command to display the switch’s ARP table.
show arp
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the ARP table:
Table 11-11 provides an explanation of the command output.
Matrix(rw)->show arp
LINK LEVEL ARP TABLE
IP Address Phys Address Flags Interface
-----------------------------------------------------
10.20.1.1 00-00-5e-00-01-1 S host0
134.142.21.194 00-00-5e-00-01-1 S host0
134.142.191.192 00-00-5e-00-01-1 S host0
134.142.192.18 00-00-5e-00-01-1 S host0
134.142.192.119 00-00-5e-00-01-1 S host0
-----------------------------------------------------
Table 11-11 show arp Output Details
Output What It Displays...
IP Address IP address mapped to MAC address.
Phys Address MAC address mapped to IP address.
Flags Route status. Possible values and their definitions include:
S - manually configured entry (static)
P - respond to ARP requests for this entry
To Next Page
Loading...
Need help?
General