Enterasys Matrix 2G4072-52 - Clear Multiauth Idle-Timeout

Security Configuration Command Set
Configuring Multiple Authentication
14-148 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.10.13clear multiauth idle-timeout
Use this command to clear multiple authentication idle-timeout values, for an idle session, back to
the default values for one or all authentication types. The default value is 300 seconds for all types.
clear multiauth idle-timeout [cep | dot1x | mac | pwa]
Syntax Description
Command Defaults
If no authentication type is specified, the idle timeout value is returned to 300
seconds for all authentication types.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to clear the idle-timeout session values for cep and mac authentication
types, back to default value of 300 seconds:
This example shows how to clear the idle-timeout session values for all authentication types, back
to the default value of 300 seconds:
cep | dot1x | mac |
pwa
(Optional) Specifies the authentication type:
• cep — Enterasys Convergence End Point Authentication
• dot1x— IEEE 802.1X Port-Based Network Access
Control
• mac — Enterasys MAC Authentication
• pwa — Enterasys Port Web Authentication
Matrix(rw)->clear multiauth idle-timeout cep
Matrix(rw)->clear multiauth idle-timeout mac
Matrix(rw)->set multiauth idle-timeout