Discovery Protocols Command Set
Enterasys Discovery Protocol
3-8 Matrix DFE-Platinum and Diamond Series Configuration Guide
3.2.2.3 set cdp auth
Use this command to set a global CDP authentication code. This value determines a device’s CDP
domain. If two or more devices have the same CDP authentication code, they will be entered into
each other's CDP neighbor tables. If they have different authentication codes, they are in different
domains and will not be entered into each other’s CDP neighbor tables.
A device with the default authentication code (16 null characters) will recognize all devices, no
matter what their authentication code, and enter them into its CDP neighbor table.
set cdp auth auth-code
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the CDP authentication code to 1,2,3,4,5,6,7,8
:
auth-code Specifies an authentication code for the CDP protocol. This
can be up to 16 hexadecimal values separated by commas.
Matrix(rw)->set cdp auth 1,2,3,4,5,6,7,8
To Next Page
Loading...
Need help?
General