Security Configuration Command Set
Configuring TACACS+
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-29
14.3.4.4 set tacacs server
Use this command to configure the TACACS+ server(s) to be used by the TACACS+ client. You
can configure the timeout value for all configured servers or a single server, or you can configure
the IP address, TCP port, and secret for a single server. For simplicity, two syntax statements are
shown.
set tacacs server {all | index} timeout seconds
set tacacs server index address port secret
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example configures TACACS+ server 1. The default timeout value of 10 seconds will be
applied.
all Specify the timeout value for all configured TACACS+
servers.
index Configure the TACACS+ server identified by index. The
value of index can range from 1 to 2,147,483,647.
timeout seconds Set the timeout value for the specified server(s) in seconds.
The value of seconds can range from 1 to 180 seconds.
The default timeout value is 10 seconds.
address Specify the IP address of the TACACS+ server.
port Specify the TCP port for the TACACS+ server. The value
of port can range from 0 to 65535, but typically, port 49 is
specified.
secret Specify the secret for the TACACS+ server.
Matrix(rw)->set tacacs server 1 192.168.10.10 49 mysecret
To Next Page
Loading...
