Security Configuration Command Set
Configuring 802.1X Authentication
14-46 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.5.3 set dot1x
Use this command to enable or disable 802.1X authentication, to reauthenticate one or more access
entities, or to reinitialize one or more supplicants.
set dot1x {[enable | disable] [init | reauth [port-string] [index index-list]}
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
If not specified, the reinitialization or reauthentication setting will be applied to all
ports.
If index is not specified, all access entities will be affected.
Examples
This example shows how to enable 802.1X:
This example shows how to reinitialize fe.2.24:
enable | disable Enables or disables 802.1X.
init | reauth Reinitializes one or more access entities or reauthenticates
one or more supplicants.
port-string (Optional) Specifies the port(s) to reinitialize or
reauthenticate.
index index-list (Optional) Specifies one or more access entities on which
to enable initialization or reauthentication control. Valid
values are 0 - 8191.
Matrix(rw)->set dot1x enable
Matrix(rw)->set dot1x init fe.2.24
To Next Page
Loading...
Need help?
General