Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-115
6.2.2.23 show spantree adminpoint
Use this command to display the administrative point-to-point status of the LAN segment attached
to a Spanning Tree port.
show spantree adminpoint [port port-string]
Syntax Description
Command Defaults
If port-string is not specified, status will be displayed for all Spanning Tree port(s).
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the point-to-point status of the LAN segment attached to fe.2.7:
port port-string (Optional) Displays point-to-point status for specific
port(s). For a detailed description of possible port-string
values, refer to Section 4.1.1.
Matrix(rw)->show spantree adminpoint port fe.2.7
Port fe.2.7 has a Port Admin Point to Point of Auto
To Next Page
Loading...
