Enterasys Matrix 2G4072-52 - Show Spantree Bridgeprioritymode

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-33
6.2.1.21 show spantree bridgeprioritymode
Use this command to display the Spanning Tree bridge priority mode setting.
show spantree bridgeprioritymode
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the Spanning Tree bridge priority mode setting:
Matrix(rw)->show spantree bridgeprioritymode
Bridge Priority Mode is set to IEEE802.1t mode.