Enterasys Matrix 2G4072-52 - Show Ciscodp Port Info

Discovery Protocols Command Set
Cisco Discovery Protocol
Matrix DFE-Platinum and Diamond Series Configuration Guide 3-15
3.2.3.2 show ciscodp port info
Use this command to display summary information about the Cisco Discovery Protocol on one or
more ports.
show ciscodp port info [port-string]
Syntax Description
Command Defaults
If port-string is not specified, CiscoDP information will be displayed for all ports.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display Cisco Discovery Protocol information for ports fe.1.1 through
fe.1.5:
Table 3-3 provides an explanation of the command output.
port-string (Optional) Displays information about specific port(s). For
a detailed description of possible port-string values, refer to
Section 4.1.1.
Matrix>(su)->show ciscodp port info fe.1.1-5
port state vvid trust cos
-----------------------------------------------
fe.1.1 enabled none untrusted 0
fe.1.2 enabled none untrusted 0
fe.1.3 enabled none untrusted 0
fe.1.4 enabled none untrusted 0
fe.1.5 enabled none untrusted 1