Discovery Protocols Command Set
Cisco Discovery Protocol
3-16 Matrix DFE-Platinum and Diamond Series Configuration Guide
Table 3-3 show port ciscodp info Output Details
Output What It Displays...
Port Port designation.
State Whether CiscoDP is enabled or disabled on this port.
Default state of enabled can be changed using the set
ciscodp port command (Section 3.2.3.6).
VVID Whether a Voice VLAN ID has been set on this port. Default
of none can changed using the set ciscodp port command
(Section 3.2.3.6).
Trust The trust mode of the port. Default of trusted can be changed
using the set ciscodp port command (Section 3.2.3.6).
CoS The Class of Service priority value for untrusted traffic. The
default of 0 can be changed using the set ciscodp port
command (Section 3.2.3.6).
To Next Page
Loading...
