Enterasys Matrix 2G4072-52 - Clear Spantree Autoedge

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-54 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.41 clear spantree autoedge
Use this command to reset automatic edge port detection to the default state of enabled.
clear spantree autoedge
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset automatic edge port detection to enabled:
Matrix(rw)->clear spantree autoedge