Logging And Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
11-132 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.6.10 set sntp poll-retry
Use this command to set the number of poll retries to a unicast SNTP server.
set sntp poll-retry retry
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the number of SNTP poll retries to 5
:
retry Specifies the number of retries. Valid values are 0 to 10.
Matrix(rw)->set sntp poll-retry 5
To Next Page
Loading...
