Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
6-94 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.2.2 set spantree portenable
Use this command to set the port status on one or more Spanning Tree ports.
set spantree portenable port-string {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Spanning Tree port fe.1.12:
port-string Specifies the port(s) to enable or disable. For a detailed
description of possible port-string values, refer to
Section 4.1.1.
enable | disable Enables or disables the Spanning Tree port.
Matrix(rw)->set spantree portenable fe.1.12 enable
To Next Page
Loading...
Need help?
General