Logging And Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
11-136 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.6.14 show timezone
Use this command to display SNTP time zone settings.
show timezone
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display SNTP time zone settings:
Matrix(rw)->show timezone
Admin Config timezone: '', offset from UTC is 5 hours and 0 minutes
Oper Config timezone: '', offset from UTC is 5 hours and 0 minutes
To Next Page
Loading...
