Enterasys Matrix 2G4072-52 - Set Linkflap Action

Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-77
4.3.8.7 set linkflap action
Use this command to set reactions to a link flap violation.
set linkflap action port-string {disableInterface | gensyslogentry | gentrap | all}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the link flap violation action on port fe.1.4 to generating a Syslog
entry:
port-string Specifies the port(s) on which to set the link flap action. For
a detailed description of possible port-string values, refer to
Section 4.1.1.
disableInterface |
gensyslogentry |
gentrap | all
Sets the reaction as:
• Disabling the interface
• Generating a Syslog entry
• Generating an SNMP trap message, or
• All of the above.
Matrix(rw)->set linkflap action fe.1.4 gensyslogentry