IP Configuration Command Set
Reviewing and Configuring the ARP Table
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-19
12.2.4 Reviewing and Configuring the ARP Table
Purpose
To review and configure the routing ARP table, to enable proxy ARP on an interface, and to set a
MAC address on an interface.
Commands
The commands used to review and configure the ARP table are listed below and described in the
associated section as shown:
• show ip arp (Section 12.2.4.1)
• arp (Section 12.2.4.2)
• ip gratuitous-arp (Section 12.2.4.3)
• ip gratuitous-arp-learning (Section 12.2.4.4)
• ip proxy-arp (Section 12.2.4.5)
• ip mac-address (Section 12.2.4.6)
• arp timeout (Section 12.2.4.7)
• clear arp-cache (Section 12.2.4.8)
To Next Page
Loading...
Need help?
General