Port Configuration Command Set
Disabling / Enabling and Naming Ports
4-40 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.3.6 set forcelinkdown
Use this command to enable or disable the force link down function. When enabled, this forces ports
in the “operstatus down” state to become disabled.
set forcelinkdown {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the force link down function:
enable | disable Enables or disables the force link down function on all
ports.
Matrix(rw)->set forcelinkdown enable
To Next Page
Loading...
Need help?
General