General Configuration Command Set
Configuring Power over Ethernet (PoE)
2-112 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.5.15 clear inlinepower psetrap
Use this command to reset PoE trap messaging for a module back to default state of disabled.
clear inlinepower psetrap module-number
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset PoE trap messaging for module 1 to disabled:
module-number Specifies the module on which to clear PoE trap
messaging.
Matrix(rw)->clear inlinepower psetrap 1
To Next Page
Loading...
