General Configuration Command Set
Configuring Power over Ethernet (PoE)
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-101
2.2.5.4 set inlinepower available
Use this command to set the percentage of total power available that a chassis can withdraw from
the total power detected.
set inlinepower available max-percentage
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the maximum inline power available to the chassis to 70 percent:
NOTE: If the total power wattage value set with the set inlinepower assigned
command (Section 2.2.5.8) is greater that the maximum power percentage specified
with this command, a warning will display. If the user opts to execute these parameters,
a ratio of assigned power will be applied to each module. Refer to the show
inlinepower output (Section 2.2.5.1) for a sample warning message.
max-
percentage
Specifies the percentage of maximum power available. Valid
values are 0 - 100.
Matrix(rw)->set inlinepower available 70
To Next Page
Loading...
