Security Configuration Command Set
Configuring 802.1X Authentication
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-41
14.3.5.1 show dot1x
Use this command to display 802.1X status, diagnostics, statistics, and reauthentication or
initialization control information for one or more ports.
show dot1x [auth-config | access-entity | auth-diag | auth-session-stats
auth-stats [all] [port-string] [index index-list] | [mac [all] mac [port-string]
[index index-list] | [port [init | reauth]] [port-string]]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Only.
Command Defaults
• If no parameters are specified, 802.1X status will be displayed.
• If all is not specified, only active entries will be displayed.
• If index is not specified, information for all access entities will be displayed.
auth-config (Optional) Displays authentication configuration
information.
access-entity (Optional) Displays access entity information.
auth-diag (Optional) Displays authentication diagnostics information.
auth-session-stats (Optional) Displays authentication session statistics.
auth-stats (Optional) Displays authentication statistics.
all (Optional) Displays inactive and active authentication
entries.
mac all mac Displays information for one or all MAC addresses.
index index-list (Optional) Displays information for one or more access
entities. Valid values are 0 - 8191.
port init | reauth (Optional) Displays the status of port initialization and
reauthentication control.
port-string (Optional) Displays information for specific port(s). For a
detailed description of possible port-string
values, refer to
Section 4.1.1.
To Next Page
Loading...
