Security Configuration Command Set
Configuring 802.1X Authentication
14-42 Matrix DFE-Platinum and Diamond Series Configuration Guide
• If port-string is not specified, information for all ports will be displayed.
Examples
This example shows how to display 802.1X status:
This example shows how to display authentication diagnostics information for fe.1.1:
Matrix(rw)->show dot1x
DOT1X is disabled.
Matrix(rw)->show dot1x auth-diag fe.1.1
Port: 1 Auth-Diag:
Enter Connecting: 0
EAP Logoffs While Connecting: 0
Enter Authenticating: 0
Success While Authenticating: 0
Timeouts While Authenticating: 0
Fail While Authenticating: 0
ReAuths While Authenticating: 0
EAP Starts While Authenticating: 0
EAP Logoff While Authenticating: 0
ReAuths While Authenticated: 0
EAP Starts While Authenticated: 0
EAP Logoff While Authenticated: 0
Backend Responses: 0
Backend Access Challenges: 0
Backend Other Requests To Supp: 0
Backend NonNak Responses From Supp: 0
Backend Auth Successes: 0
Backend Auth Fails: 0
To Next Page
Loading...
