Routing Protocol Configuration Command Set
Configuring RIP
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-9
13.2.2.5 ip rip offset
Use this command to add or remove an offset to the metric of an incoming or outgoing RIP route.
Adding an offset on an interface is used for the purpose of making an interface a backup.
ip rip offset {in | out} value
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes an offset:
no ip rip offset {in | out}
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
The following example shows how to add an offset of 1 to incoming RIP metrics on VLAN 1:
in Applies the offset to incoming metrics.
out Applies the offset to outgoing metrics.
value Specifies a positive offset to be applied to routes learned via
RIP. Valid values are from 0 to 16. If the value is 0, no action
is taken.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip rip offset in 1
To Next Page
Loading...
