Enterasys Matrix 2G4072-52 - Show Tacacs Command

Security Configuration Command Set
Configuring TACACS+
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-35
14.3.4.9 show tacacs command
Use this command to display the status (enabled or disabled) of TACACS+ accounting or
authorization on a per-command basis.
show tacacs command {accounting | authorization} [state]
Syntax Description
Command Defaults
If state is not specified, all accounting or authorization configuration parameters
are displayed (which at this time includes only the enabled/disabled status).
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to display the state of the TACACS+ client’s command authorization.
accounting Display the status of TACACS+ accounting on a
per-command basis.
authorization Display the status of TACACS+ authorization on a
per-command basis.
state (Optional) Specifies that only the status should be
displayed.
Matrix(rw)->show tacacs command authorization
TACACS+ command authorization state: enabled