Enterasys Matrix 2G4072-52 - Clear Netflow Template

Logging And Network Management Command Set
Configuring NetFlow
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-169
11.2.8.13 clear netflow template
Use this command to reset the Version 9 template refresh rate and/or timeout values to their default
values.
clear netflow template {[refresh-rate] [timeout]}
Syntax Description
Command Defaults
At least one of the refresh-rate or timeout parameters must be specified, although
both can be specified on one command line.
Command Type
Switch command.
Command Mode
Read-Write
Example
This example shows how to return the Version 9 template packet refresh rate to 20 packets and the
timeout value to 30 minutes
:
refresh-rate Clear the template packet refresh rate to the default value
of 20 packets.
timeout Clear the template timeout to the default value of 30
minutes.
Matrix(rw)->set netflow template refresh-rate 50 timeout 30