Configuring LACP
Configuring Link Aggregation
4-122 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.5.4.16 set lacp flowRegeneration
Use this command to enable or disable LACP flow regeneration. When enabled and a new port joins
a link aggregation group (LAG), LACP will redistribute all existing flows over the LAG. It will also
attempt to load balance existing flows to take advantage of ports added to the LAG. When flow
regeneration is disabled and a new port joins a LAG, LACP will only distribute new flows over the
increased number of ports in the LAG and will leave existing flows intact.
set lacp flowRegeneration {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable LACP flow regeneration:
enable | disable Enables or disables LACP flow regeneration
Matrix(rw)->set lacp flowRegeneration enable
To Next Page
Loading...
Need help?
General