Enterasys Matrix 2G4072-52 - Set Cep

Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-107
14.3.8.5 set cep
Use this command to globally enable or disable CEP detection.
set cep {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to globally enable CEP detection:
enable | disable Globally enables or disables CEP detection.
Matrix>set cep enable