Enterasys Matrix 2G4072-52 - Set Spantree Newroottrapenable

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-85
6.2.1.72 set spantree newroottrapenable
Use this command to enable or disable the Spanning Tree new root trap function. When SNMP trap
messaging is configured, this sends a trap message when a Spanning Tree becomes the new root of
the network.
set spantree newroottrapenable {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the new root trap function:
enable | disable Enables or disables the backup root trap function.
Matrix(rw)->set spantree newroottrapenable enable