Security Configuration Command Set
Configuring 802.1X Authentication
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-45
Command Type
Switch command.
Command Mode
Read-Only.
Command Defaults
• If no parameters are specified, all 802.1X settings will be displayed.
• If port-string is not specified, information for all ports will be displayed.
Examples
This example shows how to display the EAPOL port control mode for fe.1.1:
This example shows how to display the 802.1X quiet period settings for fe.1.1:
This example shows how to display all 802.1X authentication configuration settings for fe.2.24:
Matrix(rw)->show dot1x auth-config authcontrolled-portcontrol fe.1.1
Port 1: Auth controlled port control: Auto
Matrix(rw)->show dot1x auth-config quietperiod fe.1.1
Port 1: Quiet period: 30
Matrix(rw)->show dot1x fe.2.24
Port: fe.2.24 Auth-Config:
PAE state : Initialize
Backend auth State : Initialize
Admin controlled directions : Both
Oper controlled directions : Both
Auth controlled port status : Unauthorized
Auth controlled port control : Auto
Quiet period : 60 seconds
Tx period : 30 seconds
Supp Timeout : 30 seconds
Server Timeout : 30 seconds
Max requests : 2
Reauthentication period : 3600 seconds
Reauthentication enabled : FALSE
Key tx enabled : FALSE
To Next Page
Loading...
