IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-35
12.2.6.1 show router limits route-table
Use this command to display the chassis-based router limit setting.
show router limits route-table
Syntax Description
None.
Command Type
Switch command.
Command Mode
Read-Only.
Command Defaults
None.
Example
This example shows how to the route table limit setting:
NOTE: This command must be executed from the switch CLI.
Matrix(rw)->show router limits route-table
Route Table Limit - 12000 (default)
To Next Page
Loading...
