IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
12-36 Matrix DFE-Platinum and Diamond Series Configuration Guide
12.2.6.2 set router limits route-table
Use this command to set the chassis-based route table limits.
set router limits route-table route-table
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to set the route table limit to 17000:
NOTE: This command must be executed from the switch CLI.
route-table Sets the route table limit. Valid values are 1 - 25000.
This parameter will also set the maximum allowable OSPF
LSA Type 3 route limit to 8000, and the Type 5 limit to
10,000. For more information on configuring OSPF, refer to
Section 13.2.3.
NOTE: Values above the default size of 12000 routes
require 256 Mb of memory throughout the entire chassis,
and such values will be rejected if this memory upgrade is
not installed.
Matrix(rw)->set router limits route-table 17000
To Next Page
Loading...
