IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-37
12.2.6.3 clear router limits route-table
Use this command to reset the chassis-based route table limits to default value of 12000.
clear router limits route-table
Syntax Description
None.
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to reset the route table limit:
NOTE: This command must be executed from the switch CLI.
Matrix(rw)->clear router limits route-table
To Next Page
Loading...
