Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
8-52 Matrix DFE-Platinum and Diamond Series Configuration Guide
Command Defaults
• When applicable, data, mask and port-string must be specified for individual
rules to be cleared.
• If not specified, all ports will be removed from usage lists.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear rule usage statistics pertaining to all ports and all classification
rules:
macdest Clears MAC destination address rule usage statistics.
macsource Clears MAC source address rule usage statistics.
tci Clears Tag Control Information rule usage statistics.
tcpdestport Clears TCP destination port rule usage statistics.
tcpsourceport Clears TCP source port rule usage statistics.
udpdestport Clears UDP destination port rule usage statistics.
udpsourceport Clears UDP source port rule usage statistics.
vlantag Clears VLAN tag rule usage statistics.
data (Optional) Specifies an associated data value entry. Refer
to Table 8-3 for valid values for each classification type.
mask mask (Optional) Specifies an associated data mask. Refer to
Table 8-3 for valid values for each classification type and
data value.
port-string
port-string
(Optional) Specifies rule usage port scope.
port-list port-string (Optional) Specifies disabled port(s) to remove from
usage list.
Matrix(rw)->clear policy usage-list all
To Next Page
Loading...
