Routing Protocol Configuration Command Set
Configuring RIP
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-5
13.2.2.2 network
Use this command to attach a network of directly connected networks to a RIP routing process, or
to remove a network from a RIP routing process.
network ip-address
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes the network from the RIP routing
process:
no network ip-address
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to attach network 192.168.1.0 to the RIP routing process:
ip-address Specifies the IP address of a directly connected network that
RIP will advertise to its neighboring routers.
Matrix>Router1(config)#router rip
Matrix>Router1(config-router)#network 192.168.1.0
To Next Page
Loading...
