Enterasys Matrix 2G4072-52 - Page 1184

Routing Protocol Configuration Command Set
Configuring IRDP
13-82 Matrix DFE-Platinum and Diamond Series Configuration Guide
13.2.5.1 ip irdp
Use this command to enable or disable IRDP on an interface.
ip irdp
Syntax Description
None.
Command Syntax of the “no” Form
The “no” form of this command disables IRDP on an interface:
no ip irdp
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to enable IRDP on VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip irdp