Logging And Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-123
Table 11-14 show sntp Output Details
Output What It Displays...
SNTP Version SNTP version number.
Current Time Current time on the system clock.
Timezone Time zone name and amount it is offset from UTC
(Universal Time). Set using set timezone command
(Section 11.2.6.15).
Client Mode Whether SNTP client is operating in unicast or broadcast
mode. Set using set sntp client command (Section 11.2.6.2).
Broadcast Delay Round trip delay for SNTP broadcast frames. Default of 3000
microseconds can be reset using the set sntp broadcastdelay
command (Section 11.2.6.6).
Broadcast Count Number of SNTP broadcast frames received.
Poll Interval Interval between SNTP unicast requests. Default of 512
seconds can be reset using the set sntp poll-interval
command (Section 11.2.6.8).
Poll Retry Number of poll retries to a unicast SNTP server. Default of 1
can be reset using the set sntp poll-retry command
(Section 11.2.6.10).
Poll Timeout Timeout for a response to a unicast SNTP request. Default of
5 seconds can be reset using set sntp poll-timeout command
(Section 11.2.6.13).
SNTP Poll
Requests
Total number of SNTP poll requests.
Last SNTP Update Date and time of most recent SNTP update.
Last SNTP
Request
Date and time of most recent SNTP update.
Last SNTP Status Whether or not broadcast reception or unicast transmission
and reception was successful.
SNTP-Server IP address(es) of SNTP server(s).
Precedence Precedence level of SNTP server in relation to its peers.
Highest precedence is 1 and lowest is 10. Default of 1 can be
reset using the set sntp server command (Section 11.2.6.4).
Status Whether or not the SNTP server is active.
To Next Page
Loading...
Need help?
General