IP Configuration Command Set
Configuring Routing Interface Settings
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-5
Example
This example shows how to display information for all interfaces configured on the router. In this
case, one loopback interface has been configured for routing. For a detailed description of this
output, refer to Table 12-2:
Matrix>Router1#show interface
Vlan 1 is Administratively DOWN
Vlan 1 is Operationally DOWN
Mac Address is: 0001.f4da.2cba
The name of this device is Vlan 1
The MTU is 1500 bytes
The bandwidth is 10000 Mb/s
Encapsulation ARPA, Loopback not set
ARP type: ARPA, ARP Timeout: 14400 seconds
lo is Administratively UP
lo is Operationally UP
Internet Address is 127.0.0.1, Subnet Mask is 255.255.255.0
The name of this device is lo
The MTU is 1500 bytes
The bandwidth is 10000 Mb/s
To Next Page
Loading...
Need help?
General