Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
14-114 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.8.12 set cep detection-id porthigh | portlow
Use this command to set the maximum and minimum ports used for TCP or UDP convergence end
points detection. Once UDP and/or TCP phone detection has been specified using the set cep
detection-id protocol command as described in Section 14.3.8.11, the protocols will use this port
range for detection matching.
set cep detection-id id { porthigh | portlow } port
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set port 65 as the minimum port to be used for convergence end points
detection for CEP group 1
:
NOTE: This command applies only to Siemens, H.323, and SIP phone detection. Cisco
detection uses CiscoDP as its discovery method.
id Specifies a CEP configuration group ID. This group must
be created and enabled using the set cep detection-id
command as described in Section 14.3.8.8. Valid values are
1 - 2147483647.
porthigh |
portlow port
Specifies a maximum or minimum UDP or TCP port for
CEP detection.Valid values are 1 - 65535.
Matrix>set cep detection-id 1 portlow 65
To Next Page
Loading...
