Enterasys Matrix 2G4072-52 - Page 1047

IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-87
12.2.8.10 maxconns
Use this command to limit the number of connections to a real LSNAT server.
maxconns maximum-number
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes the limit of connections to the server:
no maxconns
Command Type
Router command.
Command Mode
SLB Real Server Configuration mode: Matrix>Router1(config-slb-real)#
Command Defaults
None.
Example
This example shows how to limit the number of connections to 20 on the real server at IP 10.1.2.3
in the “httpserver” server farm:
maximum-number Specifies the maximum number of connections allowed.
The default condition is unlimited number of connections.
Matrix>Router1(config)#ip slb serverfarm httpserver
Matrix>Router1(config-slb-sfarm)#real 10.1.2.3 port 80
Matrix>Router1(config-slb-real)#faildetect ping-int 10 ping-retries 6
Matrix>Router1(config-slb-real)#maxconns 20
Matrix>Router1(config-slb-real)#inservice