Security Configuration Command Set
Configuring RADIUS
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-13
Command Defaults
• If
secret-value is not specified, none will be applied.
• If realm is not specified, any authentication will be allowed.
Examples
This example shows how to enable the RADIUS client for authenticating with RADIUS server 1 at
IP address 10.1.6.203, UDP authentication port 1812, and an authentication password of
“pwsecret.” As previously noted, the “server secret” password entered here must match that already
configured as the Read-Write (rw) password on the RADIUS server
:
This example shows how to restrict all RADIUS servers to authenticate management access only
This example shows how to set the RADIUS timeout to 5 seconds:
This example shows how to set RADIUS retries to 10:
Matrix(rw)->set radius server 1 10.1.6.203 1812 pwsecret
Matrix(rw)->set radius realm management-access all
Matrix(rw)->set radius timeout 5
Matrix(rw)->set radius retries 10
To Next Page
Loading...
