Routing Protocol Configuration Command Set
Configuring DVMRP
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-77
13.2.4.1 ip dvmrp
Use this command to enable or disable DVMRP on an interface.
ip dvmrp
Syntax Description
None.
Command Syntax of the “no” Form
The “no” form of this command disables DVMRP:
no ip dvmrp
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to enable DVMRP on VLAN 1:
NOTE: IGMP must be enabled on all VLANs running DVMRP. To do this, use the set
igmp enable command as described in Section 10.4.1.2. It is also recommended that
IGMP querying be enabled on all VLANs running DVMRP. To do this, use the set igmp
query-enable command as described in Section 10.4.2.2.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip dvmrp
To Next Page
Loading...
