SNMP Configuration Command Set
Configuring SNMP Users, Groups and Communities
5-14 Matrix DFE-Platinum and Diamond Series Configuration Guide
Examples
This example shows how to display an SNMP user list:
This example shows how to display information for the SNMP “guest” user:
Table 5-4 shows a detailed explanation of the command output.
Matrix(rw)->show snmp user list
--- SNMP user information ---
--- List of registered users:
Guest
admin1
admin2
netops
Matrix(rw)->show snmp user guest
--- SNMP user information ---
EngineId: 00:00:00:63:00:00:00:a1:00:00:00:00
Username = Guest
Auth protocol = usmNoAuthProtocol
Privacy protocol = usmNoPrivProtocol
Storage type = nonVolatile
Row status = active
Table 5-4 show snmp user Output Details
Output What It Displays...
EngineId SNMP local engine identifier.
Username SNMPv1 or v2 community name or SNMPv3 user
name.
Auth protocol Type of authentication protocol applied to this
user.
Privacy protocol Whether a privacy protocol is applied when
authentication protocol is in use.
Storage type Whether entry is stored in volatile, nonvolatile or
read-only memory.
Row status Status of this entry: active, notInService, or
notReady.
To Next Page
Loading...
Need help?
General