General Configuration Command Set
Gathering Technical Support Information
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-159
Example
This example shows how to execute the show support command and save the results to slot 1 as a
support3.txt file:
There is no display example as the list of commands is quite lengthy. Click on the hyper-links in the
“Command Defaults” section above, which contains a list of the individual commands executed, for
more information and example outputs for the individual commands.
Matrix(su)->show support slot1/support3.txt
Writing output to file..................
Writing 'show config' output.....
Writing Message Log output.......
Matrix(su)->
To Next Page
Loading...
