Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3-62 Matrix DFE-Platinum and Diamond Series Configuration Guide
Command Defaults
At least one application (or all) and one policy parameter must be specified.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example returns all network policy values for all applications on port ge.1.1 to their default
values.
dscp (Optional) Clear the DSCP value to be used to provide
Diffserv node behavior for the application being
configured to the default value of 0. (A value of 0
represents use of the default DSCP value as defined in
RFC 2475.)
port-string Specifies the port or range of ports to be affected.
Matrix(rw)->clear lldp port network-policy all state tag vid cos dscp ge.1.1
To Next Page
Loading...
