SNMP Configuration Command Set
Configuring SNMP MIB Views
Matrix DFE-Platinum and Diamond Series Configuration Guide 5-35
Example
This example shows how to display SNMP MIB view configuration information:
Table 5-7 provides an explanation of the command output. For details on using the
set snmp view command to assign variables, refer to Section 5.3.4.3.
Matrix(rw)->show snmp view
--- SNMP MIB View information ---
View Name = All
Subtree OID = 1
Subtree mask =
View Type = included
Storage type = nonVolatile
Row status = active
View Name = All
Subtree OID = 0.0
Subtree mask =
View Type = included
Storage type = nonVolatile
Row status = active
View Name = Network
Subtree OID = 1.3.6.1.2.1
Subtree mask =
View Type = included
Storage type = nonVolatile
Row status = active
Table 5-7 show snmp view Output Details
Output What It Displays...
View Name Name assigned to a MIB view.
Subtree OID Name identifying a MIB subtree.
Subtree mask Bitmask applied to a MIB subtree.
View Type Whether or not subtree use must be included or excluded
for this view.
Storage type Whether storage is in nonVolatile or Volatile memory
Row status Status of this entry: active, notInService, or notReady.
To Next Page
Loading...
Need help?
General