IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-111
12.2.8.27 clear router limits
Use this command to reset chassis-based LSNAT limits to default values.
clear router limits [lsnat-bindings] | [lsnat-cache] | [lsnat-configs] |
[route-table route-table]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
If no options are specified, all LSNAT limits will be reset.
Example
This example shows how to reset all chassis-based LSNAT limits:
NOTE: This command must be executed from the switch CLI.
lsnat-bindings (Optional) Resets the LSNAT maximum bindings limit to
the default value of 5000.
lsnat-cache (Optional) Resets the LSNAT cache size limit to the default
value of 2000.
lsnat-configs (Optional) Resets the LSNAT configuration limit to the
default value of 50.
route-table (Optional) Resets the route table limit to the default value of
12000.
Matrix(rw)->clear router limits
To Next Page
Loading...
